Does A Cobb Accessport Work With Non Cobb Parts?

A: Yes, you can use a Cobb AccessPort for those parts, but Cobb’s OTS maps are not recommended for non Cobb parts. Was this answer helpful?

Will a Cobb Accessport work on any car?

Each Accessport is only compatible with certain vehicles. With many platforms, it can even be specific vehicles through specific model year ranges. Luckily, it’s pretty easy to determine which Accessport part number you need.

What cars are compatible with Cobb Accessport?

SUPPORTED PLATFORMS

• BMW.
• MITSUBISHI.
• SUBARU.
• FORD.
• VOLKSWAGEN.
• PORSCHE.
• AUDI.
• MAZDA.

Does Cobb Accessport work with JDM ECU?

That’s correct, our Subaru Accessports do not support JDM ECUs that are often imported with their respective JDM motors. You can either stick with a USDM ECU (may require some custom wiring harness work – see iWire) or move to a full stand alone ECU (which would likely require a full custom harness).

Can you tune your own car with Accessport?

You simply plug the Accessport cable into your OBDII port, select the map you want to flash, and let the Accessport go to work! In a few minutes, your car will be tuned. It really is that easy.

Is the Cobb Accessport universal?

The COBB OBDII Universal Cable enables you to connect your Version 3 Accessport to any vehicle we support!

Does Cobb Accessport add HP?

Cobb accessport will give approx 25+ hp and 14+ torque. The cold air intake from cobb will not give any more hp gains but will give the intake some noises and make the car seem faster or stronger. The stock intake is roughly good for about 400 hp.

How much HP does Stage 3 add?

COBB shows that Stage 1 adds about 20 hp and 60 lb-ft of torque with just the COBB AccessPort and a panel filter; Stage 2 adds 65 hp and about 75 lb-ft over stock with COBB’s new EcoStang intercooler system and recommended cat-back exhaust; and Stage 3 finds a whopping 81 hp and 80 lb-ft of torque with a required turbo

How much HP does a Stage 1 Cobb tune add?

Up to 10% more peak horsepower and torque.

Does a Cobb Accessport make your car faster?

Even if you have no other modifications the Accessport can still offer a noticeable increase in power that will make your car faster. The fundamental objective for increasing power is upping the amount of air and fuel we can burn in a combustion cycle.

Does the ECM have to match the engine?

In general, yes. All ECUs will need to have software intended to run the engine it is connected to. In addition, many newer cars (approximately 2008 or newer) use a CAN bus system where each component (like the ECM, BCM, PCM, etc) all need to be programmed to the VIN number of the car to work properly.

Can STi use WRX Accessport?

Accessport. SUB-004 Accessports using firmware version 1.7. 4.2-18478 and newer are compatible with the 2021 WRX STi.

Are Stage 1 remaps safe?

Stage 1 is the level of remapping that Remap Kings use as it is the only safe level for your car, allowing us to guarantee our work on your vehicle.

Does Cobb have a burble tune?

This is an option to get a burble tune created for any Cobb Off The Shelf (OTS) map. We will create a new separate tune with this featured added that you can flash and use. The burble effect is simply some pops or exhaust crackle between shifts or when coasting in gear above 3200 rpms.

Can you stage 1 tune any car?

A stage 1 tune is simply an ECU remap or chip tune. This is the most cost-effective way to modify any vehicle for performance. Turbo-diesel and turbo-petrol vehicles respond extremely well to stage 1 tuning and commonly see a 20 – 40% increase in bhp and torque.

Can you Unmarry an Accessport yourself?

If you are going to remove your Access Port, and return your ECU to stock, you do not have to take your car to a tuner. You can accomplish this yourself with the Access Port. To return your ECU to stock, you are going to have to re-write your base map, so you will need to put your car into test mode.

Does an Accessport void your warranty?

While using the Cobb AccessPort shouldn’t void your warranty, the manufacturer could deny certain claims. Plugging in a Cobb Accessport is unlikely to cause any damage, but any major modifications made to the ECU could damage the system.

How much HP does a Stage 1 WRX have?

15-21 HPF
WRX 15-21 HPF STAGE 1 | 215kW.

How much HP does a Stage 2 tune add?

Revo quote gains from 55HP up to 90HP depending on what settings are used with their software. The required hardware for their stage 2 software includes a full turbo-back exhaust with a sports-cat and a high-flow air intake.

How much horsepower does a Stage 1 WRX add?

This product is for stock cars with or without an intake or EBCS. Get your 2015-2021 WRX a custom E-Tune from JM Auto. With a stage 1 tune, you can expect peak power increases of 12% HP and 15% FtLb TQ. You can expect to get a 10-20% horsepower increase throughout the whole rev range.

What is a Stage 5 tune?

Stage 5: this would be a custom high compression big bore combination. It includes comprehensive headwork and aggressive cam. Requires larger throttle body & injectors as well as additional supportive mods. Would be considered fuel & tune sensitive.