But if you’re willing to put in a decent amount of time and effort, you can custom paint your vehicle’s dashboard at home. Whether you’re looking to improve the aesthetic of your car’s interior, or you want to repair some scratches in the dash, custom painting the dashboard can be Read more…
Normal tire pressure is usually between 32~40 psi(pounds per square inch) when they are cold. So make sure you check your tire pressure after a long stay and usually, you can do it in the early morning. What happens if you put 40 psi in tires? For instance, if 35 Read more…
Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. How do I reset my throttle position sensor? The easiest way to Read more…
Once you have fitted a Throttle Position Sensor, or TPS, you will need to calibrate it from within MEITE. First, be sure you have correctly wired, and assigned the throttle sensor signal input to “TPS Raw” in the Analog Settings. How much does it cost to calibrate TPS? Labor costs Read more…
In general no, a crankshaft sensor needs no recalibration to work properly. What happens if you don’t relearn the crankshaft position sensor? Failure to do such will result in over revving of the engine, causing possible engine damage. 8. Once the engine has returned to idle, check the status of Read more…
Acceleration issues: A bad TPS may cause all sorts of power issues. Your engine may start up but it will have little to no power and it causes it to shut off. On the other hand, it can also cause your car to have spontaneous accelerations even if you didn’t Read more…
Engine won’t idle smoothly, idles too slowly, or stalls If you start to experience engine misfires, stalling, or rough idling when the car is stopped, it can also be a warning sign of a failing TPS. What are symptoms of a bad throttle position sensor? Symptoms of a Faulty Throttle Read more…
Turn off all of the accessories. Accelerate the vehicle to 55 mph at part throttle. Cruise at 55 mph for another 5-6 minutes. Decelerate to 45 mph without using the brakes, and maintain 45 mph for 1 minute. Perform 4 deceleration cycles, without using the brakes, of 25 seconds each Read more…
Enter Security Access on the PATS control function module. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. How do I reset my Ford anti-theft? Key Insert the Read more…
PATS could be disabled with the SCT tuners. How do you turn off Ford Pats? How Do I Turn Off My Ford Anti-Theft System Insert the key into the driver’s side door lock. Turn the key once, but not all the way to unlock the door. Do this again, but Read more…