Conclusion – How to Reset a Car Computer Use a high-spec diagnostic scan tool. Turn off your car battery. Insulate the battery wires. Do a soft reset. Remove the ECU/ECM fuse from the fuse box. Observe the 45-Minute Waiting Period. Read more…
Towards the beginning of the 1970 model year, Ford introduced the Grabber Mustangs to promote their new line of Grabber colors, including Grabber Blue, Grabber Orange, Grabber Green, and Grabber Yellow. What color is Ford grabber blue? Grabber Blue is Read more…
Grabber Blue is a solid shade blue as found on the Boss Mustangs and other Ford classics. This doesn’t need metallic or pearl to grab your attention. What are the Ford Grabber colors? Towards the beginning of the 1970 model Read more…
PATS could be disabled with the SCT tuners. How do you turn off Ford Pats? How Do I Turn Off My Ford Anti-Theft System Insert the key into the driver’s side door lock. Turn the key once, but not all Read more…
Enter Security Access on the PATS control function module. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. Read more…
Turn off all of the accessories. Accelerate the vehicle to 55 mph at part throttle. Cruise at 55 mph for another 5-6 minutes. Decelerate to 45 mph without using the brakes, and maintain 45 mph for 1 minute. Perform 4 Read more…
Engine won’t idle smoothly, idles too slowly, or stalls If you start to experience engine misfires, stalling, or rough idling when the car is stopped, it can also be a warning sign of a failing TPS. What are symptoms of Read more…
Acceleration issues: A bad TPS may cause all sorts of power issues. Your engine may start up but it will have little to no power and it causes it to shut off. On the other hand, it can also cause Read more…
In general no, a crankshaft sensor needs no recalibration to work properly. What happens if you don’t relearn the crankshaft position sensor? Failure to do such will result in over revving of the engine, causing possible engine damage. 8. Once Read more…
Once you have fitted a Throttle Position Sensor, or TPS, you will need to calibrate it from within MEITE. First, be sure you have correctly wired, and assigned the throttle sensor signal input to “TPS Raw” in the Analog Settings. Read more…